Question Pool -- Category E7G
When designing an op-amp RC active filter for a given frequency range
and Q, what steps are typically followed when selecting the external
components?
-
A.
- Standard capacitor values are chosen first, the resistances are
calculated, then resistors of the nearest standard value are used
-
B.
- Standard resistor values are chosen first, the capacitances are
calculated, then capacitors of the nearest standard value are used
-
C.
- Standard resistor and capacitor values are used, the circuit is
tested, then additional resistors are added to make any adjustments
-
D.
- Standard resistor and capacitor values are used, the circuit is
tested, then additional capacitors are added to make any adjustments
See answer.
Try another question.
Choose another category.