Question Pool -- Category G
You may shorten the list of categories by choosing
one of the ten category groups.
Select one of the following categories. You will be presented
questions at random. Return here when you are ready to try
another category.
- G0A
- RF Safety Principles
- G0B
- RF Safety Rules and Guidelines
- G0C
- Routine Station Evaluation and Measurements (FCC Part 97 refers
to RF Radiation Evaluation)
- G0D
- Practical RF-safety applications
- G0E
- RF-safety solutions
- G1A
- General control operator frequency privileges
- G1B
- Antenna structure limitations; good engineering and good amateur
practice; beacon operation; restricted operation; retransmitting radio
signals
- G1C
- Transmitter power standards; certification of external RF-
power-amplifiers; standards for certification of external RF-power
amplifiers; HF data emission standards
- G1D
- Examination element preparation; examination administration;
temporary station identification
- G1E
- Local control; repeater and harmful interference definitions;
third party communications
- G1F
- Certification of external RF-power-amplifiers; standards for
certification of external RF-power amplifiers; HF data emission
standards
- G2A
- Phone operating procedures
- G2B
- Operating courtesy
- G2C
- Emergencies, including drills and emergency communications
- G2D
- Amateur auxiliary to the FCC's Compliance and Information Bureau;
antenna orientation to minimize interference; HF operations, including
logging practices
- G2E
- Third-party communications; ITU Regions; VOX operation
- G2F
- CW operating procedures, including procedural signals, Q signals
and common abbreviations; full break-in; G2H RTTY operating
procedures, including procedural signals and common abbreviations and
operating procedures for other digital modes, such as HF packet,
AMTOR, PacTOR, G-TOR, Clover and PSK31
- G3A
- Ionospheric disturbances; sunspots and solar radiation
- G3B
- Maximum usable frequency; propagation "hops"
- G3C
- Height of ionospheric regions; critical angle and frequency; HF
scatter
- G4A
- Two-tone test; electronic TR switch; amplifier neutralization
- G4B
- Test equipment: oscilloscope; signal tracer; antenna noise
bridge; monitoring oscilloscope; field-strength meters
- G4C
- Audio rectification in consumer electronics; RF ground
- G4D
- Speech processors; PEP calculations; wire sizes and fuses
- G4E
- Common connectors used in amateur stations: types; when to use;
fastening methods; precautions when using; HF mobile radio
installations; emergency power systems; generators; battery storage
devices and charging sources including solar; wind generation
- G5A
- Impedance, including matching; resistance, including ohm;
reactance; inductance; capacitance; and metric divisions of these
values
- G5B
- Decibel; Ohm's Law; current and voltage dividers; electrical
power calculations and series and parallel components; transformers
(either voltage or impedance); sine wave root-mean-square (RMS) value
- G6A
- Resistors; capacitors; inductors; rectifiers and transistors;
etc.
- G7A
- Power supplies and filters; single-sideband transmitters and
receivers
- G8A
- Signal information; AM; FM; single and double sideband and
carrier; bandwidth; modulation envelope; deviation; overmodulation
- G8B
- Frequency mixing; multiplication; bandwidths; HF data
communications
- G9A
- Yagi antennas - physical dimensions; impedance matching;
radiation patterns; directivity and major lobes
- G9B
- Loop antennas - physical dimensions; impedance matching;
radiation patterns; directivity and major lobes
- G9C
- Random wire antennas - physical dimensions; impedance matching;
radiation patterns; directivity and major lobes; feed point impedance
of 1/2-wavelength dipole and 1/4-wavelength vertical antennas
- G9D
- Popular antenna feed-lines - characteristic impedance and
impedance matching; SWR calculations
Return to index of elements.